PDA

View Full Version : I/O backplate templates



Drum Thumper
01-07-2008, 04:40 PM
I've been searching the net for the past few days and have come up with absolutely zilch.

Anyone have any suggestions? I'm looking for a backplate that will fit my Biostar TForce4 U (http://www.biostar-usa.com/mbdetails.asp?model=TForce4%20U) Motherboard. The layout looks standard, but the current case that I'm using doesn't match up.

Spawn-Inc
01-07-2008, 08:15 PM
if you handy with metal and a drill you might be able to copy a picture of one onto a sheet of steel and just use that.

Drum Thumper
01-08-2008, 04:18 AM
if you handy with metal and a drill you might be able to copy a picture of one onto a sheet of steel and just use that.

Honestly, I was considering making one out of plexi. However, finding said template is proving to be...interesting. I've got a few ideas that might work, namely scanning the I/O ports with my scanner, but that would involve nothing less than tearing down Blue, and moving the scanner over to the wife's computer, installing software, etc. I'd like to have this done so I can migrate everything to the new case and not have to worry about making the backplate at the last minute.

Eclecticos
02-12-2008, 02:25 AM
Check out the Alien Water Rebirth (http://www.thebestcasescenario.com/forum/showthread.php?t=5743). He made his own.

Airbozo
02-20-2008, 12:24 PM
If you could draw it out, I have a source, just down the street from me that carries many many I/O plates(new and used). I was able to find one for my DFI lan party UT mobo, without too much digging.