Dent

[Buclao]

I accidently forgot to use something as a layering underneath one of the side panels when I was sanding and made a dent while holding it in place using a gripper. Does anyone know how to undo the dents?

[Luke122]

If you cant pound it out using a rubber mallet, then you might have to use bondo to fill it in, then sand it smooth.

[jdbnsn]

depending on the size, epoxy often makes a good filler as well using the method Luke described. Sometimes I've heard that bondo can pop loose when sanding if your dent is too round and smooth.

[Beltar]

From my experience with bondo its great. Just make sure you apply it to bare metal and that all sanding dust is cleaned off so you have a good clean contact.