Hi

[AlphaTeam]

The top of the page says I should introduce myself in the Introduction forums which I can't find, so this will do.

I found this play looking for a way to cut an aluminum sheet. I'm not really into that many projects; I just do what I need to do when I need to--if you get my drift.

This place looks pretty cool and I hope to be here posting lots.

Regards.

[jdbnsn]

Welcome to TBCS, this is the right place for a general introduction. Where did you see that comment about "introduction forums"? I need to go change that to chatterbox.

You'll find no shortage of aluminum cutting here, exactly what types of cuts are you trying to make?

[Trace]

Before you log in, it's in the message you are shown telling you that you should register.

Welcome to the forums and good deductive reasoning skills :p