p0Pe
07-29-2008, 07:51 AM
hi there.. i just found the pics of my very first mod ever:D
it was done with:
a flat screwdriver
a hammer
and a drill
2 red fans
"lol"
the mod was a side panel which i wanted to give a little spirit:D
here is the pics. enjoy
http://tosed.dk/billeder/skullside/1).jpg
http://tosed.dk/billeder/skullside/2).jpg
http://tosed.dk/billeder/skullside/4).jpg
the test panel (sucked lol) i lost the drill a couple if times and the holes whas ugly... the nose was to big too.
http://tosed.dk/billeder/skullside/5).jpg
my pc at the time (did i mention that it was a long time ago xD
http://tosed.dk/billeder/skullside/6).jpg
the real panel. pre-drilled in some wood to make sure the holes would be where they should
http://tosed.dk/billeder/skullside/8).jpg
and on with the panel
http://tosed.dk/billeder/skullside/10).jpg
done
http://tosed.dk/billeder/skullside/12).jpg
the eyes... the cup drill didnt work to well so had to use a screwdriver to hammer it through and use a grinding bit to remove the worst leftovers:P
http://tosed.dk/billeder/skullside/13).jpg
fans on with tape on the side so that the light would stay focused
http://tosed.dk/billeder/skullside/15).jpg
finished
http://tosed.dk/billeder/skullside/16).jpg
and with lighs (the mesh isnt on here)
http://tosed.dk/billeder/skullside/17).jpg
http://tosed.dk/billeder/skullside/Billede 068.jpg
i think it was pretty good considdering it took a day and with thoose tools lol!:D
(thank god for the human ability to learn) xD
-p0Pe
it was done with:
a flat screwdriver
a hammer
and a drill
2 red fans
"lol"
the mod was a side panel which i wanted to give a little spirit:D
here is the pics. enjoy
http://tosed.dk/billeder/skullside/1).jpg
http://tosed.dk/billeder/skullside/2).jpg
http://tosed.dk/billeder/skullside/4).jpg
the test panel (sucked lol) i lost the drill a couple if times and the holes whas ugly... the nose was to big too.
http://tosed.dk/billeder/skullside/5).jpg
my pc at the time (did i mention that it was a long time ago xD
http://tosed.dk/billeder/skullside/6).jpg
the real panel. pre-drilled in some wood to make sure the holes would be where they should
http://tosed.dk/billeder/skullside/8).jpg
and on with the panel
http://tosed.dk/billeder/skullside/10).jpg
done
http://tosed.dk/billeder/skullside/12).jpg
the eyes... the cup drill didnt work to well so had to use a screwdriver to hammer it through and use a grinding bit to remove the worst leftovers:P
http://tosed.dk/billeder/skullside/13).jpg
fans on with tape on the side so that the light would stay focused
http://tosed.dk/billeder/skullside/15).jpg
finished
http://tosed.dk/billeder/skullside/16).jpg
and with lighs (the mesh isnt on here)
http://tosed.dk/billeder/skullside/17).jpg
http://tosed.dk/billeder/skullside/Billede 068.jpg
i think it was pretty good considdering it took a day and with thoose tools lol!:D
(thank god for the human ability to learn) xD
-p0Pe