View Full Version : ? Rounded egdes ?
I've been thinking about rounding the edges to a case...
Like on this one:
http://www.dansdata.com/images/pcv1000/v1000640.jpg
Could it be possible in some way to make the edges round on a case with
hard egdes ?
Sorry for my english :(
.Nawl.
richmandudeus
02-16-2006, 12:22 PM
I suppose it all depends on the frame of the case. if the frame is boxed, then some modding is required. it is verry doable though.
Would this work ?
http://nawl.wingisp.com/Something.jpg
Nawl
public_eyesore
02-16-2006, 01:36 PM
yea probaboly if your for it, but i woulnt do a rounded cut, just 2 strait ones and then a new rounded piece of metal.
SaWBLaDe
02-16-2006, 08:23 PM
i dunno bout the back of the case but as for the front u prolly could get away with using some auto body filler and give it a good sand. still its alot of work for something very minor but its very easy
jdbnsn
02-22-2006, 12:06 AM
What I would do is make one cut across the front at the edge (on the top and on the bottom) instead of the bevelled cut through the corner. Clip away what is left of the edges and use a round pipe as an anvil, then hammer your corners round. Once you have your shape, you can re-attach them with a weld, solder, rivets, screws, etc... I had to shape some stainless steel for a counter-top I worked on a while back and this method proved easier than it sounds. Just a thought...
Jon
RangerDanger
04-08-2006, 06:04 PM
yea i would cut off teh corners...then bondo the roudn edges
Cannibal23
04-09-2006, 12:43 AM
you could measure it al out and replace the front panel with colord plex. you could heat bend it where you need it . it would allow for engraveing too so you could get some nifty back lit effects
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.