PDA

View Full Version : Project:warbox



Hasbios
03-03-2006, 09:01 PM
Its my first mod and my 1st choice was which older atx case should i use
(in the back of this pic there is a wooden arcade machine. that is my 1st ever mod and it turned out quite nicely allthough the specs are poor the mod only needed to play robotron. Ahhhhhhh robotron~topscore above 1000000~beat that bitches)

http://i19.photobucket.com/albums/b194/hasbios/Picture094.jpg
i chose the one on the right

I will paint the case in either a metalic black or a camo green. ill let you guys decide which
http://i19.photobucket.com/albums/b194/hasbios/100_1173.jpg
The red marks are parts i had to hacksaw off
http://i19.photobucket.com/albums/b194/hasbios/100_1176.jpg
The circles are places where the military switches are going. each switch will control a fan. i drew a line from
where each switch is going to where the fan is going.

i will start the cutting by sunday for the switches

Hasbios
03-05-2006, 11:43 AM
The case i have is a mini atx so it will not work. however i found a normal atx i can use sorry no pix at the moment but ill keep it updated

Hasbios
03-06-2006, 12:43 AM
well i have a new case and a few more ideas. for one the new case its much taller. casehttp://i19.photobucket.com/albums/b194/hasbios/101_1211.jpg
http://i19.photobucket.com/albums/b194/hasbios/101_1214.jpg
The new side pannel looks as follows
http://i19.photobucket.com/albums/b194/hasbios/101_1215.jpg
The new large square will be cut out for a small window and the 3 smaller squares will be for 3 80 mm red led fans. the small holes are where the switches are going. as yopu can see i added 2 more switches.
http://i19.photobucket.com/albums/b194/hasbios/101_1216.jpg
im modding that older hdd mount to sit inside of the case id a diferent way.
http://i19.photobucket.com/albums/b194/hasbios/101_1218.jpg
im also putting a fan on the top(thats just to trace and mark the holes)