Antec 300 with CM 690 Premod Side Panel?

[PartyLikeARockstar]

Anyone have an Antec 300 that can test if the premodded cooler master side panel has a good fit on the case? Specs didn't show up on newegg site.

[PartyLikeARockstar]

Better yet, maybe just a template of the side window. the fan on my stock panel is about in the right spot.

[NightrainSrt4]

The dimensions of the 690 lead me to believe the side panel is too big when eyeballing the full dimensions minus the fascia.

Also the 300 doesn't use a standard sliding panel while the 690 looks like it does with those tabs on the end of the panel. The 300 has a metal U channel that hinges on the chassis that swings out 50-60 degrees, then is held in by the screws. You don't slide it in, you put it on at an angle then just drop/set it down.

EDIT: You should be able to fit a similar shaped window on the 300 though. You would just have to do it yourself. Here's a quick window I did for my little brother's 300 a while back.

Not my picture, the brother's. Don't have another.
http://i179.photobucket.com/albums/w317/volcom61691/S6300742.jpg

Just round out the edges and draw the angle out more.