cannot get air out of water loop...

[diluzio91]

Help me guys!!! ive been workin on this all day, and i cant get the loop to fill completely. i get it mostly full, and then i hit a huge ass bubble that is only there when the pump gets on.


Pump turned on
http://i838.photobucket.com/albums/zz302/diluzio91/IMG_1134.jpg

Pump turned off
http://i838.photobucket.com/albums/zz302/diluzio91/IMG_1139.jpg

im thinking all the air is inside the radiator, but cant get it out. At the moment i have 4 different fill ports installed, 2 real ones (ill post a pic below with the ports labeled.) and two fittings right above the pump made of T fittings from menards. Im getting to a point where im ready to give up. Help me out guys...

Blue = fillport

http://i838.photobucket.com/albums/zz302/diluzio91/edit.jpg

[Spawn-Inc]

you need a longer fill line on your T. just find an adaptor for the current fitting on there and use some scrap tubing. then you can remove it once you have it bled.

also while it will have a small hit on flow rates, nothing to even worry about, flip the T so it's a 90 fitting instead of a flow through T.

this is what i mean, it was for drains, but just think of the drain as where the air goes instead.

http://i386.photobucket.com/albums/oo304/Spawn-Inc/Ts.jpg

if you have it as a 90 instead of flowing straight through then it will be easier to bleed. that and have a longer tube as i said above.