Shark side panel

[Lithsanatrex]

Hello everyone, new to the forum, and not really all that new to case modding. I have a Tt shark (silver) and i was wondering if the side panel for the armor/kandalf with the 250mmfan would work with my shark.
Thanks
Lith

[The boy 4rm oz]

I think it might. If the doors r the same then it will. Check thermaltake.com or give them a call. They r really helpfull ok.

[Cevinzol]

Well I went to Thermaltake's webpage for you and looked up all three cases.
here's what I found for you:
Case dimensions:
540 x 205 x 500 mm (H*W*D) shark (http://www.thermaltakeusa.com/product/Chassis/fulltower/shark/va7000_index.asp)
530 x 220 x 560 mm (H*W*D) kandalf (http://www.thermaltakeusa.com/product/Chassis/fulltower/kandalf/kandalf_index.asp)
530 x 220 x 560 mm (H*W*D) Armor (http://www.thermaltakeusa.com/product/Chassis/fulltower/armor/armor_index.asp)
then I opened the enlarged profile views of both the kandalf and the shark. I compared them side by side. Their heights were compreable in the pictures (so it means they were photographed at the same scale). The Kandalf is much longer (from front to back) and so is its side panel.

So I'm going to say... no, the panels are not interchangeable.

looks like the 250mm fan is an upgrade when you buy a new case.
Doesn't look like you can just get a panel.
And I didn't find much about the fan on their site. Its not listed in their "DC Fan" (http://www.thermaltakeusa.com/product/DCfan/DCfan_index.asp) section under products.

Maybe you could do a little gumshoe work and get back to us with more info.