how can i put on graphic to my case

[ThaiLuNn..]

i need a tutorial to do that

i found a carbon look graphic which is using for the cars hood

first of all how can i cut it

and

how can u glue it to my case

thanx

-taylan-

[ThaiLuNn..]

http://img148.imageshack.us/img148/3927/untitledfp5.jpg

http://img148.imageshack.us/img148/6017/untitledsit6.jpg

i want to glue this graphic to this places

[Cannibal23]

is it some kind of vinal sticker? it probably has some kind of adhisive backing on it. that should solve your sticking problem. however if it does come with a sticky backing make sure you apply it from one end to the other and work out ALL the air bubbles or its going to look funny. as for cutting it probably exacto knife or scisors should do the trick.

[ThaiLuNn..]

yes its like vinly and i think i will remove back side of the sticker or i will use glue i dont know

biggest problem is cutting cause especially front side is too roundish as you can see

i need to learn how to make a pattern to cut that sticker

[tybrenis]

yes its like vinly and i think i will remove back side of the sticker or i will use glue i dont know

biggest problem is cutting cause especially front side is too roundish as you can see

i need to learn how to make a pattern to cut that sticker

To make the pattern on the vinyl, use an exacto knife to cut it out, or scissors if it's really basic.

To apply the decal -

Spray a solution of water with a drop or two of dish soap mixed in onto the surface that you want the decal on.

Remove the backing from the vinyl, and slide the decal into place. Work out any bubbles, and if you have to, pop them using a pin. Use a hairdryer to set the vinyl into the case and dry up any extra water.

[ThaiLuNn..]

the front side is problem

cutting the vinly is not a problem

making that pattern to cut that vinly is problem for me

i understand rest of them

[CanaBalistic]

Here's what i would do...

Take the case apart and clean the parts you want vinyl'd. For the front, cut a piece of vinyl a bit larger than the front. apply it to the piece and trim the excess. Put the case back together and if you've trimed properly, there wont be any edges or seams visable at all.

[ThaiLuNn..]

i was thinking like that if i can not find a solution i will go to a signboard shop to do that :D