Scratch Mod Help

[Phoenix2150]

I was woundering if someone could help me on the subject of case power switchs (the one you push to start the computer) and power LEDs. I what to know what type of switch I should use e.g. a flick, push or maybe a turn switch and what power rating/value should I take into consideration. Can I buy thos jumper cables that you plug on the motherboard that connect to the switch and LEDs? (I'm not buy a cheap case just for them).

p.s.

Be nice and I'll show you my Scratch Mod when I'm Done (It's something very different). By the way this is my First Time doing any type of real modding.

[Airbozo]

Use a momentary switch for the power. It is not pulling much juice so anything that fits and works with your mod.

I know you can buy the jumper wires but not sure where right now. I will check a few sites out and see if I can find 'em.

[DaveW]

If you go to a local computer shop, they might be able to give you some from an old case.

-Dave