Lordaeron

[SpitshineSonata]

Well i dont want to spend hours putting all the pictures of my work in here so here's a link..even though less people will see it because its not right in there face action, i hope you enjoy, and it would be awesome if i could get some pointers on what i did wrong, and what i could improve on :)

thanks

The Modded Mouse>> http://www.mawdblog.blogspot.com/

[Aero]

well, I like the idea. But I think you should smooth out the inside of the engraving, use an engraving bit on a dremal for the general engraving, then use a small file, or xacto knife to cut out the small pieces inside of it, then try to get some sand paper in there and smooth it nice and sleek. Unless thats the look you were going for :P.

Nice job.

[SpitshineSonata]

Hey, thankyou for the advice! On my next dremal project i will do that and see how it goes.

[Malatory]

also slower speeds on the dremmel and if you dont have the flex shaft look at getting one. It will help with the control of the bit.