10w Led HELP!!

Hey all, I've been having a hard time trying to find the answer for my question...

I have a Mean Well LPC-60-1050 driver and was hoping to run three 10w LED's per driver. Can anyone suggest otherwise? I'll post the specs below.

Driver:

LED's:

Lens Colour : Water Clear
Emitted Color: Cool white
Color Temp: 20000K
DC Forward Voltage (VF) : 9-12V DC
DC Forward Current (IF) : 1000mA
Intensity Luminous: 800-900Lm
Viewing Angle: 140-160°
Reserve Voltage (VR): 5V
Operating Temperature : -30~110°C
Storage Temperature: -40 ~ 120°C
Manual Soldering Time at 260°C: < 5 Sec
Reverse Current (uA) : <= 50
Weight: 6g
Dimensions: 2.9cm*2cm
Long Operation Life : 50,000~80,000Hrs

Hey, welcome to TBCS!


LED drivers work opposite of normal PSUs. Instead of a fixed voltage, LED drivers have a variable voltage and fixed current. Yours is fixed slightly higher than the forward current of one of your LEDs. So, it will run one of them but not 2 or more at once. Your particular driver was intended to drive much lower power LEDs.

These drivers can handle fourteen 5w led's "under powered" running about 3 watts piece with Cree's that are 1500ma and these 10w are 1000ma. So I'd be pushing around 12 watts a piece but I should have acquit cooling.

Technically speaking shouldn't this driver handle about 40watts @ 1050ma? These are spec's from RapidLED so correct me if I'm wrong.

Couldn't I run two 10w in parallel and drop the current to 525ma? And be safe within the specs of the driver and LED.

Its been quite difficult trying to get a straight answer about this, Here is a youtube video with 3 of these led's with the same driver and these are in series?????