gonna look soooooooo amazing when painted! (if its gonna get painted heh? :D)
Printable View
gonna look soooooooo amazing when painted! (if its gonna get painted heh? :D)
No problem mate. Looks fantastic.
Sorry guys, Its been a few days and I haven't gotten much done. Been swamped at work and other stuff going on. so I just have a few pics today.
I cut out 2 more gears to go over the radiator.
then I just glued them on.
-Thats all I've gotten done. LOL. Sorry I know its not much, but hey, a little progress is at least some progress right?
Looks good, they ALL look good. I like how you have made them all interlock.
you are officially too good at this stuff... +rep
Wow dude, you are going all out! The gears look great!
Thanks again you guys for the support!
I got some odds and ends done this weekend. I started with the relay for servo controller. This will allow the controller to turn on and off with the computer. It has its own 6V power supply.
And here is the power connector and manual switch to turn it on and off.
You can also see where I mounted the Water pump.
Next I took the side panel off and filled some of the holes and gaps with filler.
And then sanded them down.
I also worked on the front switch panel. Here is the back side without much wiring. The wiring that is there is for the dvd eject tray.
After appling 5v to 1 switch and 12v to the other 3, here is the wireing mess. I tried to add some black wire sleeving to clean things up. But I don't think I can get any better than this.
After all the wireing was done. I added the led lights to light up the panel.
These got wired in directly to the power comming into the panel.
-I also replaced the styrene bars that make the hinges of the panel with some Carbon Fiber bars. The styrene bent way to much.
Here is what it looks like from the front. -Looks like there some light comming through some holes that will require filler.
I also started to cover the front of the case.
I added some trim around the top vent.
I also added the final dvd try cover and some additional trim pieces. -I have a lot more to go.
The last thing I worked on was the Part of the logo for the other side of the case. Here it is partially cut out on the scroll saw.
and here is the final piece.
Thats it for now. -Cheers!
Your right, it did get a bit messy but well worth it lol. Great work.
wow amazing job on the switch panel & the logo!
Agreed! those things are hot!!!