Project: Mustang GT350 Hertz Edition - Finished!!

yay.. we have lift off.. cant wait to see where you take this

oooh, ahhh

I'll be watching this one :)

I measured out the top exhaust

Then comes the hood pins

And I decided to paint the drive bays

I put the bays back in

And then taped off the lines I need to paint

And did it in place

This is what it will look like when I'm done

I removed the tape. The far right is NOT messed up; that's the sticky stuff from the tape

The letters were $3

I put them on from right to left to make it line up just right

I still have the middle stripe to paint and then I'll repeat the whole process on the other side

looks good man
great start

I think it looks terrible. I'm probably just going to buy pinstping that you use on an actual car

oh... i like it.. lol

Quote:

---

Originally Posted by TheGreatSatan

I think it looks terrible. I'm probably just going to buy pinstping that you use on an actual car

---

I have access to a large assortment of vinyl and a vinyl plotter through Tuesday (hint, hint). Not sure if I have that exact color, though.

No biggie. I'll find some

I cut out the top exhaust

Then drilled the holes for the hood pins

Then cut the pins

And mixed up some JB Weld

And dropped the pins in

I decided to remove the pin striping. I'm going to use real pin striping that you buy for a car instead.

I added the black and gold pinstriping, but still need to get a 2 inch wide piece for the center