What program did you use to design that circuit?
-Dave
Printable View
What program did you use to design that circuit?
-Dave
Eagle 5.6 from cadsoft by the look of it - available as a lite version - freeware with limitations etc - download here - http://www.cadsoft.de/freeware.htm
Slave has it right! I don't know how I know the name, but I found it because I somehow knew and found they had a freeware version with limitations. So I've been using that ever since, good program too.
Here's a little bit of soldering that I did yesterday. We're going for a CPU socket type board so it makes things easier.
After finally getting new speed controllers, we tested the fan on the motor.... They're AMAZING! Infact, when I didn't properly tighten the prop adapter, at about 50-60% power, it flew up and hit the ceiling (luckily noone was hurt because we got people to stay back and the prop was fine too) but once we tightened it all up, we had no problems and we got to 80% before we shut down the system). Pictures and Videos will come later in the week.
Enjoy.
Looking good crenn. Keep up the good work.
Niiiice. Be fun to see it at 100% :D
you could probably cut down a small tree @ 100% lol
Considering those are glass filled nylon blades? I don't think we could cut down a tree.
