Printable View
Update #3 Dont have a lot of pictures tonight , but it took me two days 2 complete this update.
The case need a little something. how about some "Illumination"
it took a couple of hours over the 2 days to ecth!!!!
Doesnt look too bad
Lights on
and with the lights off
going to add a few more led to even it out!!!
looked much better in person!!!
Nice. Sweet effect! :D
see previous posts for <'s reaction to the ice cube
looks great!
Never seen this method done before :banana:, great ice cube 8):up:. Subbed.
Update 4# Just another little update.
Worked on the base as well as the fan cutout
1st I made some cuts into the case for the base to fit in.
Cut a square piece of acrylic to fit
Made some reminders
A little tapping action
attached the base
A nice solid fit
Looks like a good place for a fan
Did pretty well getting it start by hand, did finishing using the drill at very very low speed
and the end result
Looking good. :up:
Very nice!! That's going to look great when your done!
Hey!! great ice cube!! I love what you've done with that ATOM engraving!!
is there anything casting resin cant do ? im impressed \m/
