Project: Shockwave

Revived from the depths of the third page. Sorry i haven't updated in a while. Couldn't do to much for a while because my mom made me put everything back in there boxes and store them away:mad: . Well i suppose when your workshop is the kitchen/living room you might have to relocate. Thats all gonna change soon because me and my dad are cleaning the garage so i will have a place to work :D. Oh yeah i also installed the windows vista beta so that took. Anyways on to the show.

Frosted all of the pieces of plexi by sanding them with 800. These are the pics after the first sessin of sanding.
Front.

Top

I wasn't satisfied with the panels so i sanded them again.
Front, which took a long time to get it even.

Top.

Bottom.

Then I put them in place and took some pics. When it is done there is going to be two 4" blue CC behind the plexi.

dayamn thats CLEAN!
Very nice work.
H

Nice work dude, Keep up the good work.

Here is another update brought to you buy Wishiwasmodding.

Well today i decided to finish drilling out the rivets in my case. Earlier in this project i decided i would drill out all my rivets in my case and replace them with screws. The reason i am doing this is to make it easier to dissasemble if i have to do something with the case later. In total i drilled out 33 rivets to get the case fully torn down.
In the begining i started with this.

Then after some quality time with my drill i had all these pieces.

WIWM OUT.

looking good, i want to see that on the case!!