Lamborghini X2

Quote:

---

Originally Posted by tybrenis

One question.

WTF are you talking about!!?

---

:D

He's talking about the blue cover on the table.
And no, they are not used. I went to a hospital supply store and bought a
case of them (60). They are great. Light weight, waterproof plastic on one
side and soft cotton on the other. The blue side (plastic) is great for painting
without anything sticking to it. And the cotton side is great for putting things
on it you don't want scratched.

I also picked up a box of disposable hospital gloves (I think 150 pairs). Super lightweight latex I think. Not sure what they are made of. But they kind of feel like a condom. Great for painting or anything where you need to have dexterity and sensitivity. :p :rolleyes:

Quote:

---

---

I don't like that. Is there no way you can rotate the socket in the plate so that the wire hangs straight down?

Quote:

---

Originally Posted by MDCS

But they kind of feel like a condom.

---

Paraphrasing Drac998: Not used, I hope.. :p

Quote:

---

Originally Posted by xmastree

I don't like that. Is there no way you can rotate the socket in the plate so that the wire hangs straight down?

---

I didn't care for that either. But I wanted a heavy gauge and it's the only
one I had that fit the way I wanted. It's not bent too bad though.
And ... I can still hit the reset button if needed. :D

I also added a flip top cover for the compressor, with the back open to
breath better. And put the heavy 4mil on the floor.

:)

Q:what does tha reset buton (me do'no:? )

you can take the socket out and turn it around. Just remeber to turn off the power.

Quote:

---

Originally Posted by Drac998

you can take the socket out and turn it around. Just remeber to turn off the power.

---

That's what I thought too.

i used to do some electrical work in my highschool auditorium....theyve made it a new building code that you have to have the wall connectors with the ground pin up....for the fact of...if say a piece of paper fell and contacted between the 2 leads...that would make a nice little fire :eek:

Quote:

---

Originally Posted by GT40_GearHead

Q:what does tha reset buton (me do'no:? )

---

Probably an ELCB built into the socket. Nice, but I still think it should be inverted.
The chance of a piece of paper falling onto the two pins is much lower than the chance of catching that wire sticking out.
Building codes are for new buildings. Screw the building code and use common sense. ;)

Quote:

---

Originally Posted by GT40_GearHead

Q:what does tha reset buton (me do'no:? )

---

Could be a GFI (Ground Fault Interupted) socket. Basically the socket has a resetable circuit breaker in it. They are required/recommended if there is an electrical socket around any type of water, such as bathrooms, kitchen sinks, washing machines or in this case maybe the hot water heater.