Um well its not really UV. It is just green acrylic that happens to glow under any type of light. I "took" off cuts from my school. I know that they buy it in 5x5m square sheets. The AC Ryan plexi squares are basically the same as what I am using.
Printable View
Um well its not really UV. It is just green acrylic that happens to glow under any type of light. I "took" off cuts from my school. I know that they buy it in 5x5m square sheets. The AC Ryan plexi squares are basically the same as what I am using.
o ok sweet i want to get some for my comp thanks
No problem buddy.
ok so like i would like to know like wich one is better the q6600 or the e8400
Well as far as I know the Q6600 is kinda rated as the new E6600, great value and a good over clocker. Personally I think a CPU like the E8400 is overkill. I don't really know much about the E8400, you should send Luke122 a message, I know he is using one and got a pretty good OC with it.
ok i well ask luke122
Well very little happening on my end. I am just getting bits and pieces together so when it comes time to put the case back together there is minimal fuss.
I have however done the final little adjustments to the drive bays.
I cut this hole to pass some molex cables through from the PSU to power all the fans, CCFLs etc. It is a bit sharp so time to put some fan hole molding on it.
Before:
After:
Next we have the hole I cut in the mobo tray and the PSU support.
Before:
After:
Here is the cut I made to allow fan cables to enter the drive bay area.
Before:
After:
While I was at it I decided to also cover one of the mesh edges that was visible on the drive bays.
Before:
After:
And finally to cap it all off, two progress pics.
Pics:
damn...thats lookin clean...i cant wait to start my UV project
i dont hand these out too often but +rep
edit: just a small thought i had...are you going to be doing anything with that fan hole in the top? maybe cut it out...and either put a grill or make one to go over it ...then line the outside of it and the fill port with some more UV green goodness?
I didn't intend on changing that top fan hole, I quite like it how it is at stock. It will looks good with a blue fan under it anyway. I will look into some options and report back later.
Thanks for the +rep b4i7
dude that looks so cool i cant wait to see when it is done. god i wish i could do what u have done so far
