Printable View
Update!
To start with the.. UV-green acrylic behind the front holder. Make sense?
Piece cut to size. Holes tapped and drilled. Then cut away what needs to go. That's one of the ways you could do...
Tadaa!
Cool, until I was drilling the holes.
Would have been cool, so let's make a new one.
Drilling the holes before doing any filing didn't turned out good either.
S*&^@*&(*Q#!
Something completely different..
Not completely useless... Because,
Side shields for the back. Made them out of alu either. Same story as seen before I guess? I forgot to take pics of... Backside of the PSU is almost done, just needs to be sanded an polished...
Still frustrated from the broken acrylic I decided to start with something completely different :) .
Scrap.. (alu ;) )
Sanded down.
Errrrrrrrr.... The upperside of the case.. right?
Ahaah!
I needed something for that.. Something. Smart. And I didn't know where to mount it .. more in the front, or in the back. So:
Figure saw and some filing work was needed..
Tadaa!
Front:
Back:
Middle:
The PCB for the CRT wil be covered by a housing/shielding. That will provent the rest of the case from radiation and high voltages. But most of all it's just for fun, looks and to hold cables. Same style as the PSY ofcourse ;) . I will mount some acrylic between the alu and the PCB. Yeah, more next time ;) .
All reactions arre welcome again ;) .
Stop! Hammer time!
All updates are copied :) . Enjoy the rest of my worklog.
Welcome to TBCS! Been following your work over at BT for a while. GREAT Stuff. Looking forward to your next update.
@ slytherock, b4i7 and OvRiDe: Thanks guys :) .
That's some nice work there!
I look forward to the rest of this build. +rep
I have to admit, this is top notch work. Good worklog style too!
-Dave
Daaaaaaaaaaaaaaaaaayyummmmmm!!!!! Awesome work man! Welcome to TBCS. +rep.
Great work! welcome to TBCS and +rep
Thats some nice work you did so far ! Keep it up :)
