Printable View
i should stop chatting till late at night and go on mod something more :hurt:
but anyways a quick update
glued first side panel.. while im typing this i recognize that i wanted this side removable to the pump :dead: :dead: :dead: so il just will use the front side for accessing :devious: and here my first drybrush experience
jupp updates here
next side panel ready and glued
marking the bottom panel
everything is glued int, ill try to make it a bit waterproof so if some water gets on the loos int wont go to the elektrical stuff (shouls stop listen to KoRn while typing in english its worse anyway :D )
sound and vibration proof, this will be silent ill hope
ok, this is the cover for the cd cover, but i couldnt remove the mainboard because this was to far, so i took out my *i forgot that friggin name*-saw and cut it for about 2mm, but yes this friggin tiles had to remove theriselfes :dead: :dead:
i glued them back, weird that i had some left over... :rolleyes: :rolleyes:
guess whos back in my laboratory :eek: :eek:
anyways i marked the hard guy and glued the res, then i ran upstairs, fast :D
i think ill go for the name "parker" mh... or better mary jane? :D :banana:
water cooling block arived, its a used one so there are some bad spots
this needs some polishing
done ^___________^
:banana: htis will be the second res, needs alot of modding before it could move in
the first 30 seconds are relevant and used in every vid ill upload
:D
the base of the res made with mounting foam
marked a hole
holed a hole xD xD
:dead: :dead: :dead: :dead: :think: :dead:
again drilling again tile regluing again some left over :D
trusty rusty
the foam was almost dry so i started shaping, but ill have to wait until its complete dry
first coat of bondo, already cut into nice form
thats really all of today
this is what the res shall look like... kind of :D
yooooo, got a brand new water cooling pump, eheim, german quality :D :D
unfortunatly the pump is way bigger than the old one, so ill have to expand the pump housing
:think: :think: :think: looks kinda weird :think: :think:
res 1 got a rustpainting today :)
thats all more to come 8)
:) update :D
finally got my hands on mdf so i started work with it
bout an hour later, lots if routing sanding and blablabla later i got this
just how i wanted
heres my sec res with wc connector
3 holes, the outer for the UV LED's and the middle for the straw
bingo!
marked the spot for the hinges
some angle grinding later
top cover, needs some modding aswell
but the pump tower is almost finished
makro shot :)
thats all 4 today :)
daily update w00t
top cover is final sanded and smooth :D
intake connector for the res
drawed on the backpanel for the rad and the PSU
some holes...
some cutting
after some filing and sanding the ras fits in nicely and holds without screws :D
a shot in place
and this is where the psu goes in
thats all 4 today, tomorow more of this :D
