[Project] Modularis Evolution - it begins... updated daily!!

Still looking great, and you're lucky to have a bending rig. I remember using a table, bar, and some clamps to bend steel and it was agony.

Thanks guys. yer i bought it when it was on sale down from £80 to £35 so it was a bargain!!!

lovly mod you have there great work with the plexi +rep

Thankyou :D

ok guys time for another update!!!

ok the rest of the psu housing has been bent!

and the side bent

And on the side

And now just a quick mock up using parcel tape to show you lovely people how this is going together

Its pretty big!

Hdd housing alu marked out

And bent and joined

and put on top of the psu housing to show how it goes

I hope you enjoyed it and tune in tomorrow :D

Josh

looks gooood man!. keep up the nice work:D

(may i call you bender? bender rodriguez :D)

LOLOL!!! umm i guess you could doo as long as you dont mean it in a derogatory way! hahaha

Josh

ok guys on with the next update....

I started off the day by cutting out the front and back sections of the hdd housing.

Then I marked my third 4'x2' sheet of 1.629mm alu for the metal I needed for the dvd housing.

And bent

I then cut out the top section

I then quickly got to work on the pump/res housing

And that is all for today :D

Tomorrows plan of action is to cut and bend the rad housing and then cut the ends for the dvd, pump/res and the rad housings.

Hope you enjoyed this update

Josh

intence... you aint waisting your time ill give you that lol, looking foreward for next update:)

Nope if i waste time i will just get too bored i need to do everything now...

thanks for the comment.

:D josh

hey guys,

Time for another update. unfortunately its alot smallre as i have been with my girlfriend more today.

but i did get this done :

I started by cutting the lst side panel for the pump/res housing (excuse the wonkyness i just plonked it on for the photo.)

i then got the alu cut out for the two parts of the rad housing.

and got the first part bent

and that is it for today.
more tomorrow though (hopefully quite a bit more!)

tomorrows plan:

bend the second section for the rad housing
cut out the ends for rad,pump/res,cd/dvd

Then after that is done i will lay it out how it will be (without the supports) to show you guys just how big this beast will be!
then it is onto the acrylic work!

Josh