Printable View
thank you m8´s!!!!:D:D
today we integrate another power plug and a On/Off Switch in the backside of the case.....
after that we cutted the first 3 parts of the sidepanel mechanism....
i think tomorrow we´re going to concentrate on the opening/closing mechanism so that we can show you how this will work....:)
I love this forum it never ceases to amaze me the skill which is put into your work if i can do half as good as this i will be happy
thanks a lot!!!
like i promised we started the building process of the sidepanel opening mechanism.....
then we attached the first parts to the case...
...just to see where we have to make the next cuts....so that the sidepanel can be opened completely
That is nice work there.
thanks a lot guys!!!
in the last days we were busy on planning another gimmick we want to place inside the front.....
therefore we made a rectangle hole inside the backside of the front....inside the hole we want to mount a small webcam....
then we quick draw on the otherside....
and put on a bit more bondo....
and we cutted the raw video material we shooted up to now....so here are the first 2 parts of the video worklog....:clap::clap:
Nice progress.
Very nice work...
At first I wasn't sure where you where trying to go with this mod, but the farther you go the better it gets!
You can be sure I will be following along...
+rep for tinking out side the box...literally! ;)
That is some great work, I love the ideas. +rep and subscribed.
thank you all!:D
in the last days we made some progress on the Holder for the Water Reservoir...
at first we bended the 2 Plexi Holders for the rez into a 90° angle
then we drill out some plexi circles....
and cutted them into 2 halfs
.......at least we drilled 3 holes in all of them......then we put 3 plexi rods through the half circles so that we got an element which will be placed between the bended Plexi Holders for the rez....
Wow that looks cool, keep it up =)
