Update!
Got the painted HDD mounts mounted back to the HDD:
Got the slot cut out for the video card ports:
And mobo set in to check alignment:
It's angled because the heatpipes on the cooler hit a few caps on the board and it angles the card ever so slightly. It's worked like this for quite some time now, so I'm not worried :D
Next up I cut and glued the final piece of fabric for the back of the case:
And after a trimming with a nice sharp razor blade:
Mobo finally mounted in place, along with HDD, new CM red LED fan, and red IDE cable:
I also got the RFID reader mounted in it's spot :D
I pulled the CPU cooler off to swap the neon UV green sleeving for some red, and I'm also going to put a 68-Ohm 1/2-watt resistor in the power line to slow the fan down. It's loud at full blast, and this mobo doesn't have any kind of fan control, and I don't want to hook up the fan control that came with it, because that's just more wires to deal with and try to hide, and I never have a reason to have the fan above minimum speed anyways.