All radiator screw holes are right above the tubes in which water flows so screwing too far will puncture the tube. I did so with my first swiftech radiator and I was able to get a new one for free...
Type: Posts; User: butvinjd; Keyword(s):
All radiator screw holes are right above the tubes in which water flows so screwing too far will puncture the tube. I did so with my first swiftech radiator and I was able to get a new one for free...
Thanks for the tip. You have been a ton of help.:banana:
From what I've heard, I should sand the inside with fine gritt, put two coats of primer then the spray. Am I right in assuming this?
Orbital Jigsaw and Dremel set comes today...pretty excite about that.
Still need to figure out what paint I can use that will coat the inside black but make it so that it's non reflective.
Columbus here. Native of Cleveland.
Pictures will come when I actually get the time to start the modding. I have some stuff still in the mail, such as my jig and dremel set. This is not going...
I think I will just go with the modders mesh now that you mentioned it. I did some searching to see how people have been using it and it's pretty nice stuff. Since my cuts in the top will match the...
I used the nibbler to cut out mesh, and I think that's the most I will end up using it for. Picked up a nice orbital jigsaw and I will get some bosh blades as recommended. There is no way I'd ever...
Sorry for the delay, I have been out of town and AFK. Here are some pictures, although they wern't taken myself. (I'm at work and not near the case).
For a clear explanation, here goes...
The...
Hello all.
You guys really know your stuff here so I'm sure this would fall into the rookie category.
I am going to be cutting the top of my case (drill & jigsaw) to make a large enough area to...
Do the teeth on the blade have to be a special kind, or can I use just a normal saw blade that would cut through wood? I remember hearing awhile ago that you should get a special blade for cutting...
It requires a starting point, drill hole works fine. If it works how its supposed to, a rather small drill hole would be ok, as the fitting that you cut with is pretty tiny.
I will update if I...
Nibber or Nibbler, either or. I got one and I haven't used it yet, but I have been told that they are great for cutting aluminum or thin steel. Anyone used one before?...
Alright, I have browsed over the forums here at TBCS for a long time, and I have admired all of the work that is done here. You guys really know your stuff.
Compared to what you all do here, I...