[artoodeeto]

sweet! That's the same epoxy stuff I used to cast a few parts on the sandcrawler. I found it hardens almost completely in about 24 hours. Did you use a mold release of some kind? They should have come out pretty cleanly if you did (although I used a latex mold rather than plastic, and was able to peel the mold off my casts). I also used a resin spray on the casts after they came out to ensure that their outer surfaces were nice and hard.

I didn't truly appreciate what a nice case this is until I happened to see one in Fry's this evening. Looks awesome, even without doing anything to it! Your mod should be some pretty awesome improvements.