My server was down duo to a server swap
So I dont think you are going insane bro
Time to get on with this, so it will be somewhat ready to S7 Lan at my school
First of all, I have been busy with some other stuff that I will post tonight, or tomorrow
But i will give you a teaser:
Anyways, on to the big and expensive thing that I am about to cut holes in
So, as mentioned earlier i had to cut off a piece of the mobo tray to make it fit with the radiators.
Also had to cut off the two thingies that I think is supposed to hold some feets for the mobo tray, if you want to use it as a bench table
Like a glove! Fits lovely in there!
So, got my hands on some raw material! From this,
I made this. But what is it? I will show in a min.
First, I cut a hole in the case
This hole lines up with the radiator in the other side. You see, instead of connecting the two radiators with tubes, I will just connect them with the piece shown in the previous pic.
So just put it in, make it go into the radiator on the other side aaand...
Mount radiator number two
Saves me a couple of fittings, and it looks darn clean!
Here you can see it connected to the two radiators
That was all for now fokes. I have some dye coming in, so that I can hopefully colour the 3d printed stuff in a real black, and not some brownish like the last dye I got
