Here are some more pictures of my progress,...
My work area,...
My work table. I made this table just for this project. See the 2 x 3's bolted to the underside of the table,... I'm going to bend some sheet metal over the table and those 2 x 3's and use that are for bending acrylic.
Side panel half taped off,...
Side panel ready for markings,...
Marked with rounded corners,...
My snack,...
Window cut out,...
Rounded corner,...
Some of the tape peeling up,... not good, but not a problem.
Panel ready for filing,...
I sandwiched the panel between some 2 x 8's to and some long clamps to get it to stand striaght up and to cut down on vibration while filing.