Saturn Magnetosphere.

[Eclecticos]

This Pipe needs to slip over that pipe without catching.

I have a drill press out in the shop, but I lost the key.
So I've been walking around the house, watching tv, boreing them out LOL.

Here are all the pieces going on top. I'm going to cut the domes off the top of the other PVC End Caps,

. . and put Lines in the side of the pipe to let the air out for fans, or put some motorized reservoirs up there.

[Eclecticos]

Now I have to put a set screw in through the side of that hollow bolt to hold it on the motor pole.
And attach the motor to another crossbeam on the top of the PC Case.

As the bolt turns, The pipe will ride the beam up, and down.
I have to get some motors that go forward and reverse.
I might have to make a guide in the sides of the PVC if it decides to spin.

[Eclecticos]

Well my scroll saw wouldn't cut the side panel so. .
I got the jigsaw out and made a square and Put my aluminum panel behind it.

Should I cut some fan holes out?

I still have allot of filing to do, it was all just so scratched up I had to paint it.

[Eclecticos]

I found a Ole' Label maker and made a Sticker for my WorkDesk.

[Eclecticos]

Continuing Work on the Side Panel.

[Eclecticos]

Still Needs some fileing down to be square, But other than that, painting, and Installing Fans
This is about as much as I wanted to do with this side.

Any suggestions are welcomed.

[Eclecticos]

looking good! you aren't going to be using those fan grills right? something like mesh would look better

Well I had Planed on it.
Here is what I'm doing now.

What if I removed all but the outer circle and put mesh behind it?
I have some left over from the top piece on page 5.

The only thing I don't like about the mesh is it tends to block allot of air from getting out
so by raising it . .will let the air out and still look Kewl.

[Eclecticos]

Cut the fan area out and left some burrs to hold the port into place.

Just a Speakerbox port and a Snipped Fan Grill.

Added some Mesh over the sqaure on the mounting panel.

I just realized I have my fans pointed away from eachother.
Though I have no way to correct it because there will be nothing to attach the dome to. .

[Eclecticos]

Needed some Windex on the other side.

Here is what it looks like under the dome.

With the Lights On.

I turned the fan around.

WhoooHoooo. . .
Spins around and round.

[Eclecticos]