Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Project: Brushed metal

  1. #11
    ATX Mental Case tinker's Avatar
    Join Date
    Nov 2007
    Location
    ohio
    Posts
    167

    Default Re: Project: Brushed metal

    Yea. I have been. Newegg, Tigerdirect, and xoxide.
    Its just hard to choose one without seeing it in real life.

  2. #12
    How much faster can you render the bsod? Ap1thy's Avatar
    Join Date
    Jun 2007
    Location
    New York
    Posts
    244

    Default Re: Project: Brushed metal

    xclio has a propellor case for $40 (newegg), dont know if its the right size, but the basic design is nice and clean and the side panel would make a good mod, it has a 360mm fan attached but you can remove it and put in a window or smth. only problem is that it may be a bit in the flimsy side, when i was putting in the fans and the i/o shield it flexed a lot

  3. #13
    ATX Mental Case tinker's Avatar
    Join Date
    Nov 2007
    Location
    ohio
    Posts
    167

    Default Re: Project: Brushed metal

    yea. I looked at it and its a little on the small side for what I need.
    (17.8'' x7.3'' x 16.3'')

    Thanks for the suggestion though. I think I'm going to wait until this weekend to drop by a few pc repair and thrift stores to see if I can get anything worth while. I that fails I will order the case the following week.

    Any suggestions or hints are still much appreciated.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •