[Project] Modularis Evolution - it begins... updated daily!!

[FuzzyPlushroom]

Thankyou yes it is coming along well but My digi slr broke today!!! my tripod fell over and it was secured to the top of it!!

That's always a bitch - lost my old point'n'shoot PowerShot A40 that way. I don't use that tripod anymore.

Good to see that the glue'll hold... Should make things a bit easier.

[x06jsp]

Yer im going to try and get the camera fixed when i get paid at the end of the month!

[p0Pe]

that looks really god and welcome to tbcs. be sure to have a look around we have lots of stuff

i must say, its helluva projekt you got going there! but looks like you know what you are doing

+rep

[x06jsp]

Thanks pope and i will take more of a look around later not got much time atm

anyways who wants another update...

ok guys update!

second template done

then 3 green bits marked for cutting

And cut

four black bits for cutting

And cut

And then all together

in the process of gluing

filed

sanded

and polished

and this took 1 and a half hours!! and i have another 20 to do!!!!! oh well.

and i haven't done the holes in it yet i am going to try it out on the test one before i do this one and muck it up.

Josh

[p0Pe]

you aint wasting your time huh? alot of updates very fast xD keep em´ coming!

20 you say? damn... gl hf

[x06jsp]

Lol yes 20!! and yes i like to mod mod mod and then update at least once a day during the week then break at the weekend.

thankyou

[x06jsp]

Ok guys well i tried out drilling the holes through the support and it worked out quite well but i noticed if you drill all the way through you will chip the side that the drill comes through whereas if you drill most the way through so that the drill is just poking through then turn over and drill the other way you dont chip it.

I then decided to move on to the next module.... so here goes

step by step :

1. i mark out the piece that will be bent

2. then cut it out

3. then grab your 30"bending brake

4. mark where you want it bent

5. start bending untill you think its about right

6. grab your set square with a handy 45degree angle on it

7. check angle its not quite right just bend some more and if its too bent then just push it back with your hand.

8. repeat stages 4-7

and that is it for today guys.

hope you enjoyed it

Josh

[The boy 4rm oz]

Those spacers turned out teally well. Nice job.

[x06jsp]

Thanks

[p0Pe]

like the spacers MUCH! i need one of thoose bending things -.-