I have my cut out for the case door ready and I was wondering about the application of this for the door. In Paul and John's book Maximum PC Extreme PC
Mods, he used some adhesive spray on the Far Cry tower. While that is an option, I was thinking about applying some blue painters tape (low tack) and then laying some carbon paper on top of that and tracing the pattern on to that. While there is no problem there, I am wondering if when I start to cut it out with a jigsaw will the jigsaw "lift up" the tape.
Another question is that he used a jigsaw blade that had 24 TPI and the case was aluminum. I have a steel case (Thermaltake Xaser II) and am going to use a bit with 18 TPI. This should be appropriate right?