hopefully we can get the project done but i have an idea i have to wait for a bit i have three different computers i'm working on so have a lot of work i try to get on later
get it warrantied if you've got nothing important on it. I had my 500GB Seagate crap out on me, and I'm not warranting it because I've got data I need to get off. Needless to say I wont be ordering another Seagate drive, my next one will be a WD to go with the WD400 I already have
Arctic Cat * Maximum Security * Cribbage Board * Rockin Case * Armor Redux
Tempest SXR * Power House * Red Comet * ICHIWZ * Acrylic Headphone Hook
Continuing sponsorship support from PCBoard.ca
Completley agree, i plan on heading back to said place of purchase so ill ask if i can get it replaced, also remember this is not for me, all "my" computers run WD hdd's
Will
Ok so new hard drive aquired, old one couldnt be replaced as it had "physical damage" to it so there goes $119.00 down the drain. But it could be worse, so far i have cut out half the rad hole and started drilling the holes for the motherboard. Still need to cut the hole for the psu in the back drill the hole for the power switch then prime it and paint it, cut the plexi side, install the componants and there you go Pcclan will have a computer again. Then when we get up the money it will be water cooled and i will finish the custon waterfall res. Until then.
Will.
Will
Whats that? Is it a bird? Is it a Plane? No it's an update!
Wow finally a photo update
first up there is a photo of my shop when its empty in my lexa worklog, well heres a pic of it when it's full
onto bussiness, we started by cutting the io shield hole
then drilled the standoff holes, i used three standoffs to raise the board
then we cut the psu hole
and finally the hole for the video card to poke through
well thats all we did today, tomarrow we will paint the case red
till then.
Will
Will
Nice.
You actually got some more work done on it. +rep
I wouldn't even hold anything that close to the chevy that might even have the slightest chance to scratch. Work log looks good.
we are painting the case right away, here's a link for you Snowman http://www.cardomain.com/ride/3099886
Will
Will
Well anyways, we just finished painting the caes, its not perfect but it's a LOT better than what it was
Heres the plexi cut
Well that's all for now, going to wait like a day for it to dry so i will start installing the parts tomarrow.
Will
Will
ok so i fitted the parts and they all fit like a charm, unfotunately the sata cables to the hdd and dvd burner are not long enough though so we will be picking those up sometime this week and the power button will be here wenday, im just on my lunch break so pics will be up when i get home.
Will
Will