So I have gotten kinda lost on my previous builds. Project Karbon kinda just halted, not being tossed aside but still put on hold. Project: Fish tank media pc is also put on hold. I have all the parts to finish it, I just don't have an acrylic bender or the materials to make one, so yet another, on hold. But I think I have one that I might be able to finish in the near future. I think I am going to shut up now and let the pictures do their talking.
Stock case without fascia
Opened up a bit
Top taken off
Taken bays out
Taped and marked where to cut on the top
All went well until the holes for the fittings needed to be drilled. Should have done first maybe?
Oh well, I compromised.
The motherboard finall fits. I cut out the other side of the 5 1/4 bays.
The top put back on with the PA120.3 and 6 Scythe SlipStreams
Holes for fan cables. (going to be sleeved later).
My extension/ G3/8 to G1/4 adapter.
The order before I started on the case.
2 heatkillers+Bitspower goodness.
PA120.3
More Bitspower goodness.
Tasty
More hardware pr0n