Thank you man! Glad you like it I LOVE to make something noone have seen before
This will be the last update this week, and its just a little tiny one I am curently waiting for some parts that should have been done in the 3d printer, but it is broken again... This time it was a little bit my fault But lets not tell that to anyone
This is my humble workshop Or, when I need to do something, I make that table there lol... This is also where I take most of my photo´s
I took a piece of scrap acrylic and cut out a square,
This fittet right into the psu hider (lets just call it that for now)
And then the top plates goes over. When a pattern is cut into this, you will then see the acrylic behind This will of course be backlit