Zebracorn - The Xbox in a PC Case Mod

[AmEv]

I think someone found out that 2*3.5 bays was the right size for 3 very small fans (30mm, I think...)

[xr4man]

i'd use these to start with and modify as necessary.

3.5"
http://www.performance-pcs.com/catal...ducts_id=27179

5.25"
http://www.performance-pcs.com/catal...ducts_id=27177

[SchaibleTech]

I think someone found out that 2*3.5 bays was the right size for 3 very small fans (30mm, I think...)

Oh ok. Well I don't need more fans, just going to be unnecesary noise. It's the thought that counts tho!

i'd use these to start with and modify as necessary.

3.5"
http://www.performance-pcs.com/catal...ducts_id=27179

5.25"
http://www.performance-pcs.com/catal...ducts_id=27177

THIS IS EXACTLY WHAT I WANTED. You are the man, thank you.

[xr4man]

no problem.

[SchaibleTech]

Been crazy busy lately and have not had time to work on this project. Also have run into a few issues.

I think the motherboard has RROD'd beyond fixing. It wont stop red ringing even after new thermal past and the x clamp fix. Might have to use one of my motherboards...which means I'll have to re solder everything, buy a new DVD drive to swap out the I/O boards, and re do a lot of stuff. Kinda sucks and is pushing me back.

I got the final layer of paint on everything, now i just need to spray paint the decal on the panel so I can clear coat it, then put everything back together and get the sheet metal.

Thanks for staying tuned.

[AmEv]

Have you thrown it into the oven to try to fix it?

[SchaibleTech]

That was my last resort..ahha

[SchaibleTech]

Teaser photo! Here is the first coat of paint on the front bezel. Custom switch plate up top.

[SchaibleTech]

And a mock put together.

[AmEv]

Have you gotten the 360 DVD drive prepped for the front bay?