Medal of Honor Warfighter Ammo Box

[ozzylow]

Medal of Honor: Warfighter

Yes i know this is forum is mainly focused on PC modding, i have followed this site for a long time now and posted a few Xbox cases before. I get a lot of my ideas from PC modders and follow a lot of there builds. If this is in the wrong section and you would like it removed, please do so.

New project for the month, this will be based on Medal of Honor: Warfighter developed by Danger Close and published by EA.

The Xbox 360 motherboard will be placed inside an Ammunition Box

I have done this before, but used two ammo boxes that were stacked on top of another. I was happy how this turned out, but I know there was plenty of room for improvements, This time going for a cleaner, single box look with a theme.

The ammunition box will need to be shortened in length as it is too long

Controller compared in size to the case

I removed the rubber seal around the lid, these cases are watertight the handles are tight on this case and its not something I want to struggle with opening and closing the case.

Some of these designs will be re done on the case once finished, as well as some Medal of Honor based text and designs

Perfect condition inside the case

Medal of Honor Facebook

Medal of Honor Twitter

Medal of Honor Youtube

Previous projects

[ozzylow]

Bought a new 4GB Xbox 360 S this week to use in the project, with the spare case I might make another built in screen for another project.

There is a few Youtube videos showing how to take apart the Xbox 360 S. Ill show some basic pictures of opening the case.

Pry open the top grill

Top and bottom surround

Take care when taking the faceplate off as there is a ribbon cable that will easily tear.

Drilling out each of the small welds on the support bar, wanted a cleaner look on the case

Pry it up and the bar should remove easily, with minimal damage to the case

Ventilation holes

[ozzylow]

Decided I will not be chopping this case, all that work to take out a few inches does not seem worth the effort. I don't mind a larger case. Support bar left some marks, sanded back what I can and will finish off with some filler

Sanded back the lid and a coat of primer

[licenseless]

i like it... but i have seen a mod almost just like this before... cant remember where

[licenseless]

found it...

http://forums.bit-tech.net/showthread.php?t=209830

anyways... if you do that... i have one suggestion...

see in this picture where the guy put his usb stick

you should do that too... but make a usb stick like a 20mm round...

they go for 5 bucks here
http://www.keepshooting.com/20mm-dummy-bullet.html

i have one as a beer tap knob... they are neat to have... and if you can find one thats made out of brass you can polish and make it looks nice...

these are the brass ones

[ozzylow]

That is my last ammo box case that I did. Thanks for the suggestion I will be doing that again. I have a brass bullet casing USB already. Thanks

[ozzylow]

Still deciding on colours, I don't want to stick to the standard green again, maybe matte black or a dark grey with the stencil lettering and maybe some engraved badges of the Danger Close and EA logo's.

Thin coat of filler

[licenseless]

That is my last ammo box case that I did. Thanks for the suggestion I will be doing that again. I have a brass bullet casing USB already. Thanks

hahahahah no wonder they seemed similar...

well i really liked the last one you did... so much so that its what i think of every time i see some one else making a computer case out of an ammo box... so in my eyes... you set the standard with your last case... lets see what you do next man...

exciting!!!