To put it simply, I am awe struck by your work.
Re: Hp Res 3 Mega
To put it simply, I am awe struck by your work.
Re: Hp Res 3 Mega
I love the motherboard back panel and I'm anxious to see the top feature finished!!! Great work man!
Re: Hp Res 3 Mega
Hey guys ,Nice to get back into this mod.
while i was waiting for some parts to arrive for H-1 i'd get a bit of work done on hpr3.
As much as i liked the first fan box, it was drifting away from the internal theme i was going for.
I decided to make the Fan box again!and this time keep it plex rather than bondoing over it.
I decided to rout the edges this time and also do the inner circles.
Last edited by jdbnsn; 02-18-2012 at 02:50 PM.
Re: Hp Res 3 Mega
Because the PLEX is soo thick this time "10mm" i had to countersink the screw holes.
The routed edges are shined clear with flame.
Last edited by jdbnsn; 02-18-2012 at 02:52 PM.
Re: Hp Res 3 Mega
the end result one lit proper the box wiill become a light feature inside the case as well has being a fan holder.
Last edited by jdbnsn; 02-18-2012 at 02:54 PM.
Re: Hp Res 3 Mega
Not quiet sure whats to say about this next mod for HPR3!
just decided to do it!thought it would work in well with the rest of the mod and it's a great way to spend a sunday arvo
Plex PSU
Off to the plex shop and get some cut to size bits!
next was to measure and install some stand offs
a quick check....this is just ageneric 400watter from an oldserver
Some heat sink bending will be needed!!!!!
Some drilling!!!
Some fitting of a switch and power socket
Last edited by jdbnsn; 02-18-2012 at 02:56 PM.
Re: Hp Res 3 Mega
Some sanding with wet and dry to get that nice frosted finish...1200g is used.
Some wiring/soldering back up up wires!
The outer walls are glued on and the 120mm fan is added.
Last edited by jdbnsn; 02-18-2012 at 02:58 PM.
Re: Hp Res 3 Mega
Some drilling thread tapping and countersinking of holes are done to secure the lid.
The end result!!! i may still give the edges a hand beveling for a rounded look.
Last edited by jdbnsn; 02-18-2012 at 02:59 PM.
Re: Hp Res 3 Mega
Hows it look?
Its nice to be getting some work done to this again
Last edited by jdbnsn; 02-18-2012 at 03:01 PM.
Re: Hp Res 3 Mega
I like your work. This is my kind of work. Great job. Question,... the top piece you made. You are going to heat it and form it so that it contours with the top of the case right? Tell me you are? I would love to see that and I'm sure everyone else would too.
Posting Permissions
Reply With Quote
