Hp Res 3 Mega

[tribaloverkill]

Bravo dude. Bravo.

[DR_K13]

More!

[Defyant]

Defyant style frosted plex HDD light.



I decided to scratch the the top panel mod... i like the mod!! it looked sexy..but for me, the mod was just too overpowering

and overshadowed what i wanted to be the main feature of hpr3mega...

i decided to still make a feature... and thinking that i still needed a HDD signal light i'd try somthing that i thought would be sleek stylish and suit this mod better.

the top panel of HPs come apart into 2 sections, the panel that pops out has a nice round edge with a sunken middle..i decided to use this part to install the new custom
HDD light.





first off was some crude marking

close eunf was good enuf as the new plex light could be made to fit the shape.

using some thin sheet plex and scissors cut out a template

transfer the shape onto some 10mm plex and cut it out.

putting the cut peice underneath you can see it wont sit flush!!!

some some channel edging is done to allow a section of the plex to raise up thu the hole and sit even with the top of the panel..

some heat is applied to the plex light to get the contour of the top panel...its bends three ways!!! but a few goes got it perfect.

a fit up to see all is good.

[Defyant]

next it was inside for some final wet rubbing for shape and a one more to get the frosted themed look to match the rest of this mod.


40 mins later and some very wrinkly finger tips the new light was created!!

Next was to try a fit up...

and of course....lights action! i was impressed , i think thiswill look very classy flashing to HDD activity and wont over power the whole mod as the original idea would.

of course! dual colours will be added!

[public_eyesore]

you are absolutly amazing

[toast07]

wow simplyfrikin amazing man i love it

[Defyant]

MEGA RES


You all knew HPR3-MEGA was going to have a "MEGA" res! but what no one was to know was the external effect of this res was to be.

the back custom back board lighting effect was not only to provide light internally but externally as well!!

The board gives off more light then id ever expected.. and is truly an amazing effect to see in RL.. and will also provide light for the MEGA RES Feature!


First off was to finish building HPR3's Mega-Resthis is is HUGE..and it had to be @ 400mm long and 80mm accross the RES is going to be a main feature.


i opted this time for full 10mm thick tops and bottems as these would also act the the main and only anchor points for the MEGA res.


the partially built res.

Top peice and 1/2" fittings

the HEX head bolts that will secure the res to the motherboard back wall.


using a "thing-a-majig" to find dead centre of the circle, these things are great.

the innner thread on the bsb gas type fittings is 12mm spot on. an 11.5mm drill is used for the holes.

[Defyant]

DRilling and tapping the threads.

A good clean thread is important a perfect seal is a must.

Next is to drill and thread the top and bottem of the MEGA res

Next drill and counter sink the motherboard back panel.This will allow the HEX head bolt to sit down flush and avoid touching the MB..also looks spiffy too!

Bolting up the MEGA res for as test run! a view from inside the case....i think you can already see the light effect this is going give off!

Again the flush fitting of the HEX bolt.

a view from the outer side.

[Defyant]

NEXT! was to put those LED's to good use!! and i gotta say......its great to see somethings just work to plan!


the first shot was under almost full light....and still i was impressed.

Next was with one light on in the workshop

Finally lights out!!!!!!! the MEGA res looks so classy really catches the light off thr back panel.......

Next was to try the MEGA res with the "bondo'd" custom side panel......the effect is more than i'd had hoped for... thelight that comes thru is very even and intense.

Whats that i hear you say?? "but defyant! dosn't the back panel have "RED" lights as well!"

Well it sure does guys take a look see HPR3's Mega Res can not only look cool! but RED HOT as well

[Defyant]

And perhaps for the most amazing side bonus of having both RED and BLUE lights!! heres somthing i didnt see comming!

im having soooo much fun playing with this new technique.... and i may still "frost" the whole res yet!!

More soon guys.