BRUBCAT (BRUnos Black CAsemodTower)

[Brunhold]

Hello folks!

1st) Nice Forum, full of good work and ideas!
2nd) Sorry for my bad english, I am from germany, hope you understand, what I want to tell you. If anyone finds spelling mistakes -> keep it!
3rd) I want to present my finished casemod, so let me read your opinion!

Casemod features:
- plasmaball with lift
- motorised door
- switchable colours
- neonlight (2 Tubes, 2 switchable colours: blue/red)
- running light in frontcover (10 LEDs, yellow)
- underbody illumination (20 LEDs, 2 switchable colours: yellow/green)
- "Eye" in frontcover (2 LEDs, 2 switchable colours: blue/red)
- atomsign over power supply unit(30 LEDs, 2 switchable colours: yellow/green)
- stylebox on the side (4 LEDs, 2 switchable colours: blue/red)
- DVD-Drive-Stealthmod

The hardware inside/outside:
CPU: AMD Athlon64 3500+, 2200MHz, S939, Winchester
Cooler: Thermaltake Silent Boost K8
Mainboard: Gigabyte GA-K8N Ultra-9
RAM: 2x MDT-DDR-RAM 1024MB, PC400, CL2.5
HDD: 2x 80GB Seagate ST380817AS 7200rpm, SATA, NCQ, Raid 0
Graphix: Gainward GeForce 6800GT, 256MB DDR3, PCIe
VGA-Cooler: Arctic Cooling NV Silencer 5 Rev 2
TV-Card: Terratec Cinergy 1400 DVB-T
PSU: Be Quiet! 350W ATX, PFC
Monitor: Samtron 98PDF, 19" CRT and Fujitsu Siemens Comp. 4612 FA, 18" TFT


Here are some pictures from the construction:

After the window, the door has been cut out. Next steps: Primer, sanding, primer, sanding, primer, sanding...

I did not like the bottom plate, that is why I made this cover. It is made of a CD-ROM-Board, a busted TFT-Inverter and a network adapter.

The lift raises the plasmaball only 2,5 cm or 1 inch, but it is better than nothing.

The underbody illumination with switchable lights.

Here you can see old paint. The pipes and the box have no function, are not mounted yet. Everything is just decoration!

The mess has to get cramed inside.

[Brunhold]

I finally found my pictures from the tower!

Some Details:

[Brunhold]

Hello guys!

I haven't been lazy in the last 2 months and now I want to present my "new casemod". Well, it is a case, but it's called "desk"!
It has now lights inside like a refrigerator, a motorized drawer and door.

Here we go:

The light inside:

Scanner was out of order, now parts of it are pushing and/or pulling the drawer:

A detail-photograph from the servo, whitch opens the door:

This is controller box:

And here is the VIDEO!

Enjoy!



Link To Original Thread