Short story. Recieved DOA PSU for review. Took out 14cm fan and a little fan speed controller. Built custom shroud to hold 14cm fan on a CPU cooler. Am clueless if I could actually use fan however.
Fan:
14 cm. Very quiet.
1 - yellow/black two-pin male connector.
1 - red/black two-pin male connector.
Circuit board:
1 - red/black two-pin male connector.
3 - female two-pin connectors.
Wiring wise, I'm pretty clueless. Could this be hooked directly to the CPU fan plug on the motherboard? Could/should the circuit board be used to control fan speed? Any suggestions would be appreciated.