14cm PSU Fan on Custom CPU Cooler?

[moon111]

Short story. Recieved DOA PSU for review. Took out 14cm fan and a little fan speed controller. Built custom shroud to hold 14cm fan on a CPU cooler. Am clueless if I could actually use fan however.

Fan:
14 cm. Very quiet.
1 - yellow/black two-pin male connector.
1 - red/black two-pin male connector.

Circuit board:
1 - red/black two-pin male connector.
3 - female two-pin connectors.

Wiring wise, I'm pretty clueless. Could this be hooked directly to the CPU fan plug on the motherboard? Could/should the circuit board be used to control fan speed? Any suggestions would be appreciated.

[Spawn-Inc]

i would think you can use it, just need to change those 2 x 2pin plugs to 1 x 3 pin plug. you don't need the black on the yellow i think. and you wouldn't need the speed controller since the mobo (usually has one built in).

[Redundant]

Would you mind peeling up that golden sticker so we may see which wires are duplicates?