Due to popular demand, picture progress report.
Started back up today after a little break to recover from man flu & lack of enthusiasm due to spending absolutely ages cutting the 10mm panels.
Got all the 10mm, 4mm cut & 1 of a heck of a lot of the 3mm panels done, it is getting easier but there is some high detail 3mm panels to be done & have no idea how long those might take I would do those next but I could do with getting a stronger spray adhesive to make sure it stays held down for the whole panel, soooo many cut outs to be done on them & this spray adhesive is only any good for simple panels.
Also shown here is the drill helpers, these particular ones are for drilling spot on on bars & on edges, I'll make a bigger one for big flat panels, will help make sure every single mount position is 100% perfect on edges of the 10mm panels & on any panels with a normal power drill.
On to easier thickness of 3mm now, then 2mm then 1mm then adding all the drill mount points then an epic sanding session, then acrylic which cuts incredibly easy on the saw then gluing some of the acrylic parts together, then hmmmmm woooooooo hoooooooooooooooo.
Because I've gone to such lengths on the design it would probably be able to be mass produced also but have no plans at all for that but it is my most complete design so far.