Thanx guys, youre the best !
Ok ok last modification for the rear-legs; by combining two ideas of readers ( thank you for that! ) I made two sections, one thicker sandwich from circuitboard, plexie and circuitboard. And one thinner and smaller one with one circuitboard less.
To bring back the aluminium-look, I used a 3mm strip to hold it all together.
Looks nice with a little light behind it.
I glued the read-write heads to the legs and then sanded the whole smooth.
I just had to modify the large arms with more circuitboard, to get it more "in-sync", agreed?
With the EL-tapes on, in the light you dont see much of them...
...but in half-light it looks just as I expected it would.
Still have a hard time making pix in the dark, but this should give you an idea.
And the other side.
And front/top.
An overview with the flashlight.
This is the end of the work-log. I hope you enjoyed reading it as much as I enjoyed making the case.
Frenkie