Project: Ark of the Covenant Mod

[985323]

How did you manage to bend your bit like that?

[TheGreatSatan]

Mad Skillz!

[DonT-FeaR]

rofl i was gunna ask the same question lol if u snapped it i would get it but bent!?!?!?!?!

[TheGreatSatan]

Here's the gold layer on the pillar

I cut off the top piece of mesh so that the board will lay flatter and it left a cool effect.

So much more to do and this is where I'm heading...

[DonT-FeaR]

nice keep it up do indy proud

[TheGreatSatan]

I've got more ideas for this mod and am heading to the store to get them. BTW, heres the ark that I'm basing this all off of.

[TheGreatSatan]

So more work to show.

This is what I'm shooting for.

Here's how I'll do it. I used good ol' expanding foam to fill in the pillar

I have this thin rod

I had to cut it to size

Then I dropped in the rod

And drilled a hole in the plywood base

I checked to make sure that the rod will fit.

And shaved off the excess foam

Then all I had to do was set the pillar on top and push the rod through the top and bottom.

Three to go.

[DonT-FeaR]

wow thats incredibaly easier than what i would of come up with

[TheGreatSatan]

Unfortunately, expanding foam continues to expand for hours. I went downstairs this morning and the foam had expanded more and pushed the pillar away from the case before drying. I'm gonna have to shave a bit more off and try again.

[DonT-FeaR]

bugger have fun