Project: PrometheusCu

[ShockTheBox]

how are the noise levels with the kama kaze fans.... I was thinking about using a push pull fan set on my rad just for giggles.. so if you have time to make a comment on the fan noise i would love to hear it.... nice work .. +rep

[Langer]

OMG, that radiant acrylic is so cool.... It would be perfect for -yet another- project I have in my mind's eye. Thanks again for planting idea seeds Mach. (lol... Unobtanium... that movie was so bad).

The covers on the GPU blocks will be installed differently when It's all done, with a bit of an edge finish, some spacing and with screws.

Thanks guys.


The Scythe fans are pretty loud on full boar, but that wont be necessary 90% of the time. On 1/2 power they aren't that bad.... but I don't mind the extra dB's

[The boy 4rm oz]

Now that is some cool looking plexi.

[Langer]

Just ordered the 4x 64GB SSD's from NCIX.com

G.SKILL FM-25S2S-64GB 64GB 2.5IN SATA2 SSD

Performance Specifications
Sequential Read Rate 155MB/sec (MAXIMUM 170MB/sec in Vista)
Sequential Write Rate 90MB/sec (MAXIMUM 100MB/sec in Vista)
Access Time >0.2ms

[The boy 4rm oz]

Damn, no expense is to much lol.

[DonT-FeaR]

you never stop amazing me... let some one else have a go

[mittelmeier]

That looks amazing! +rep

[Langer]

@The boy 4rm oz - it's my own fault - the design didn't leave room for anytihng but SSD's - even the velociraptor is 2mm too tall.

@DonT-FeaR - Yes sir =(. hehe.

@mittelmeier - Thanks man.

[craigbru]

@The boy 4rm oz - it's my own fault - the design didn't leave room for anytihng but SSD's - even the velociraptor is 2mm too tall.

Only 2 mm? Heck, a hammer would fix that for you...

[markkleb]

lol, or a hydraulic press. Just stop right before contact of the spinning disk