Skull cut out

[Rankenphile]

oh man, I love those. Very very cool.

You know what else would look cool? A thin layer of smoked plex over frosted UV green or blue, so that when they lit up, the entire thing would light, but otherwise it's jsut black.

[Malatory]

If I get the time to make it .. I will make sure you know about it. I need to get working on a couple of my mods and finish them up.

:Note to the Above: Why not use the 2way Mirror Plexi

[Malatory]

ok quick pick of the test run I did .. there are lots of mistakes and I sanded down the front because of one of the mistakes ..

but this is about 30mins of work. Did this while I was waiting for a program to build.

[Sh0ck]

looks good. the nose needs to be closer together to line up with the cut out lines from the top and bottom like this:

You probably just have it sitting on that mesh just to test, but just to let you know.

[Xato]

That looks hot.

[OvRiDe]

Nice work for 30 min..

[Malatory]

looks good. the nose needs to be closer together to line up with the cut out lines from the top and bottom like this:

You probably just have it sitting on that mesh just to test, but just to let you know.

No I its glued down already

What really needs to happen is the nose need to be turned a bit more .. the flat side that should be up and down as the bridge is / \ part.

It was done with left over parts as I am waiting for the UV Blue acrylic for a project to come in (Hope I have some left over to do this right).

all the things I have found wrong with it. (Yes not bad for a quick try at it)
Nose
Was not able to leave the surface clear. I had someone tip over my Model Glue as I was also fixing my step sons airplane.
top part of the head is not well rounded (might be from me trying to make it a circle not a Oval).
Not lined up on the Mesh.

But I am being nit picky about it.