Are you sure? When I first came up with 1/8", I wasn't thinking about both sides of the tube. I even made up two drawings of it to make sure I had the right answer.
Are you sure? When I first came up with 1/8", I wasn't thinking about both sides of the tube. I even made up two drawings of it to make sure I had the right answer.
also this supplier.
http://www.mcmaster.com/
page 3444
Thickness of the plexi= (OD-ID)/2, since the outer diameter means the whole tube you are getting both walls included in the measurement...
US Plastics is the best! I get all my supplies from them.
In a time of chimpanzees I was a monkey.
They seem to have a great selection of poducts. Though I recieved an e-mail from them about my order. The tube that I ordered is only available is 6 foot sections, so I have to change my order to 6 feet of tube before it can be sent. If it's only available in 6 foot sections, why not just give me 6 feet in the first place.