Project: Rage

[Fuganater]

I'll give it a shot. If not I might try to make my own. Or buy another... not really expensive.

[msmrx57]

Or you could wire up your own led's for the feet.

[Fuganater]

I put a 62 Ohms resistor in place of the one that burnt out and it worked fine. Though after about 3 minutes it got pretty hot. What size should I try next? FYI 62 is the biggest I have so I have to order in some.

[Twigsoffury]

I put a 62 Ohms resistor in place of the one that burnt out and it worked fine. Though after about 3 minutes it got pretty hot. What size should I try next? FYI 62 is the biggest I have so I have to order in some.

http://t0.gstatic.com/images?q=tbn:A...4ZAjkGLQRP&t=1

??

[SXRguyinMA]

I put a 68-ohm 1/4W resistor in-line with a CPU cooling fan it hardly gets warm. I put 1/8 (TINY) resistors in my LED setups and they don't get warm at all. If a resistor that big got that hot something's not right

[Fuganater]

Its 4 x 5mm Red LED's.

[Fuganater]

Got the backplates in today for the GTX 560Ti's. I'm painting them now and will install tomorrow.

[Fuganater]

So I painted the backplates and got them installed. They greatly improve the look of the case.

Also the cards have a much more "snug" fit. Which is good because I thought the weight of the water blocks would hurt the cards eventually.

Later this week I will play with the case feet LEDs again and see if I can't get them working better. I might have to order some new resistors but I'll probably wait and just pick them up in the states when I'm on vacation.

Cheers till next time.

[TheMainMan]

Wow, that's really nice looking! Very clean and seemless appearance.

[SXRguyinMA]

I agree, great job, looks awesome